Defining a short implant
In the literature, "short implant" is generally used for implants of 8 mm or less, and "extra-short implant" for those of 6 mm or less. Their diameter may be the same as standard implants or slightly wider; the only difference is the length. The surface and thread design of modern short implants aims to achieve adequate anchorage in bone even with a short body.
Why it comes up: bone height in the back of the jaw
After teeth are lost, two anatomical limits come to the fore in the posterior jaw: the maxillary sinus in the upper jaw and the inferior alveolar nerve in the lower jaw. As bone resorbs after tooth loss, these structures come closer to the ridge and there is no longer room for a standard-length implant.
At this point there are two paths. The first is to build up the bone: sinus floor elevation in the upper jaw, vertical bone augmentation in the lower jaw. The second is to choose an implant that fits the existing bone. The short implant is the tool of the second path.
The literature: survival, surgical time, patient-reported outcomes
In a multicentre randomized trial, 6 mm short implants were compared with 11–15 mm implants placed with sinus floor elevation. At one year of loading, no implants were lost in either group; in the short-implant group surgical time was shorter and the authors reported that early patient-reported discomfort may be lower (Thoma 2015).
A meta-analysis pooling eighteen randomized trials found no statistical difference between extra-short and longer implants in 1- and 3-year survival; in the short-implant group biological complications and surgical time were lower, while prosthetic complications were slightly higher (Ravidà 2019). The authors emphasize that long-term effectiveness still needs to be investigated.
Limits: variability, loading, prosthetic design
The other side of the same literature also needs to be seen. The ITI consensus report gives survival for implants of 6 mm or less as 86.7 to 100 percent and notes higher variability and lower predictability compared with standard implants (Jung 2018). This does not mean that short implants "do not work"; it means that case selection and prosthetic design need to be done more carefully.
Points watched in practice:
- Bone quality: In soft bone, a short implant may find it harder to gain anchorage.
- Crown-to-implant ratio: If a long tooth sits on a short implant, the lever effect increases; the prosthetic design must balance this.
- Load: Planning is done differently for people who clench or grind their teeth.
- Splinting: Loading several short implants with a connected (splinted) prosthesis can distribute the load.
Who it is for, and who it is not
A short implant comes into consideration in these situations: people with limited bone height in the back of the jaw; those who do not want a sinus lift or a large graft, or who are not suited to them for health reasons; those who wish to keep treatment time short.
In these situations, other routes are usually evaluated instead: cases where bone width is also insufficient (then the issue is not only length), very low bone quality, and situations where the prosthetic design requires forces large enough to strain a short implant.
Frequently asked questions
Is a short implant lost sooner?
In appropriately selected cases, medium-term data show comparable survival. For the long term the literature is still accumulating; that is why the answer given is not a "definitive" one but one "for your case".
Why isn't everyone given short implants?
Because bone width, bone quality and chewing forces differ from patient to patient. In some cases, a longer implant with augmentation gives a more predictable result.
Is it placed in a single session?
Usually, yes. The timing of the prosthetic stage varies with bone quality and planning.
This article is for general information and does not replace a clinical examination. Suitability of any approach can only be decided after examination and imaging.